Surface preparation is essential. So use a wax and grease remover on the bonnet according to the directions on the bottle of the wax and grease remover you are using.

You should also consider using light to medium sandpaper on the areas of the hood surface where the flange of the hoodscoop will contact the hood itself. This will provide a lot of additional adhesive strength.

There is a risk if the surface is not prepared correctly, that the hoodscoop will not adhere to the surface of the hood adequately and because of that will come off.

In addition to the double-sided automotive tape supplied it is recommended that Sikaflex or Polymax is used . For extra security and adhesion, and we recommend using pop-rivets or bolts.

Do not wash the vehicle for 24 hours after installation.

Once fitted correctly your Ford Ranger will look even more awesome then before.

You can only buy genuine Kut-Snake hoodscoops from an authorised dealer.

All Kut-Snake products come with a Kut-Snake CreditCard Multitool as token of our appreciation for you as a customer : Have a look here

Find some more awesome products in our webshop:

• More for your Ford Ranger 
• Recovery gear. 
• Adventure Gear
• Towing Mirrors

Kut-Snake fender flares are also an awesome addition to your Ford Ranger : Have a look at this video

Kut-Snake hoodscoop for your Ford Ranger PX2 are some of the best looking hood scoops in the world, brought to you by Adventure Trucks

https://www.adventure-trucks.com/product/spatbordverbreders-ford-ranger-px1-px2-en-px3-95-mm-breed-gladde-afwerking/